A Federal Aviation Administration official supervised, tested and approved a communications upgrade in El Dorado, Arkansas, eight minutes before radio services began failing across much of the U.S. air traffic control system on Friday, The Washington Post reported, citing a person close to the investigation.
The account complicates efforts by Transportation Secretary Sean Duffy to pin the nationwide ground stop of roughly four and a half hours on contractor L3Harris Technologies. At the small El Dorado site, an L3Harris technician was moving communication lines from old copper wiring to fiber optics. The FAA official was present for the changeover, tested the new equipment and signed off on the finished job, according to the person.
The agency had also approved detailed plans and carried out an operational risk assessment before allowing the work to proceed before a busy travel weekend. "This site is very small. There are very few services. It was not considered a risk," the person said.

Cause still unresolved
Duffy has said a new router at the Arkansas site flooded the network with more than 1,000 connection attempts every few seconds, and he has questioned whether "incompetence" at L3Harris was to blame. The person close to the inquiry said that view overlooks the FAA's own supervision and that the precise cause has not been established. The FAA and L3Harris are examining the router at a laboratory in Florida, and HPE, which makes the Juniper devices, said its equipment worked as configured.
Asked for comment, the FAA pointed to Tuesday's news conference at the Capitol, where Duffy and FAA Administrator Bryan Bedford spoke and Duffy said he wanted L3Harris to "hire better minds" and was weighing bringing in other companies. L3Harris has stopped installing the Juniper routers, though 68 are already in service. The broader modernization program is about 70% complete and could wrap up late next year.
Photos: Getty Images via Mashable, AFP.